All The Basics About Preparing For Rubber Vulcanizing For Your Operations

Before you can vulcanize your parts, they need to be prepared correctly by assembling them together and making sure that they are clean and free of any oils. Parts should be assembled as tightly as possible without being forced together, which may cause air pockets inside the part once it has been cured. If you are using a chemical curing system where there is no heat involved, then make sure that the parts are completely dry before assembling them together because this will help with the cure time for your project. The following information will guide you through all these steps in the conveyor vulcanizing process:

Cleaning

The most important part of the vulcanizing process is cleaning the components of your equipment. You want to make sure that all dirt and debris are removed from the surface before the vulcanizing process can take place. Talk with the service doing the vulcanizing to determine what chemicals are best to use for the process.

Greasing

In addition to cleaning all the surfaces of your equipment, you also want to make sure that all the parts of the equipment are operating smoothly. Thus, you will want to grease any moving parts that are essential to the movement of the conveyor system. After the parts have been greased, you are going to need to check the drive mechanisms that move the conveyors.

Lubricating Driveshafts

The conveyor system you have installed uses a type of PTO driveshaft, which transfers power from a motor and moves the belt. Since there are a lot of surfaces that are going to be vulcanized, you want to make sure they are working properly. Thus, you want to make sure all the PTO shafts of your conveyor system are well-greased before the vulcanizing process can take place.

Once the greasing of parts and lubrication of the driveshafts have been completed, clean up any excess residue that can cause problems with the vulcanizing process.

Gasket replacement

In addition to greasing the driveshafts, there might also be seals and gaskets that need to be replaced before beginning the vulcanizing process. Make sure that all these seals and gaskets are replaced to protect your equipment from damage that the vulcanizing process can cause.

Tightening Bolts Parts to Prevent Issues After Vulcanizing

Once the preparations have been done to the conveyor equipment, you want to make sure the equipment is assembled properly. Thus, you need to check all the bolts and fasteners to ensure they have been properly tightened. This will prevent equipment from being damaged during the vulcanizing process.

If you have a conveyor system that needs to be vulcanized, contact a conveyor vulcanizing service to get help getting this work done. Contact a conveyor belt vulcanizing service near you to learn more.

Share